Accessories

Floor bracket for mounting air curtains to the floor.

Loose 20A 6-pole repair switch. Loose, lockable repair switch

Pre-assembled, shielded data cables for connecting air curtain systems to the control panel, or data cables for connecting air curtain systems to master/slave units, equipped with RJ45 (ISDN) connectors.

Automatically controls the air curtain(s) when the gates or doors open.

Depending on the length of the device. Powder coating according to RAL

Wall brackets with top-mounted fastening devices, including threaded rods, vibration dampers, and locknuts. Depends on the length of the device.

Flexible heating connection with screw fittings for the supply and return lines.

Room Temperature Sensor – RT-FD (only when used with CAT and CAT E).

Electronic supply air temperature controller with 0-10V actuator and supply air temperature sensor, fully installed and wired. When used with the CAT 300 controller, it maintains a preset supply air temperature at a constant level.

230 V / 50 Hz, normally closed. For automatic control of the heating water circuit. In summer mode or when the air curtain is shut down, the water circuit is closed. The use of an antifreeze thermostat and a strainer is recommended.

For automatic control of the heating water circuit. During summer operation or when the air curtain is shut down, the heating water circuit is closed (normally closed). The use of an antifreeze thermostat and a strainer is recommended.

Used to monitor PWW heat exchangers when there is a risk of frost. As soon as the temperature drops below +7 °C, the fans are turned off and an optional solenoid valve opens.

For easy, vibration-free ceiling mounting, consisting of M8 or M10 threaded rods up to 1,000 mm in length, vibration dampers, turnbuckles, and locknuts.

In automatic mode, this turns on the door air curtain at the preselected settings.

Limits the supply air temperature (adjustment range: +20 °C to +35 °C). Constant supply air temperature limit. Also available as a 3-way valve.